Securitex Electronic Systems Engineering

CCTV division (Twisted Pair Technology)

Twisted Pair Transmission Transceiver - Passive Series:

manufactures high quality, unshielded twisted pair (UTP) CCTV video transmission equipment. With a new range of video transmitters and receivers

for distance up to 2.4 Km. Simply find a spare pair of CAT 5 cable near the camera or source video and cross connect through the building (s) to where you

plan to put your monitor, multiplexer, DVR, or destination device. The advantages of this type of system are clear video signal, fewer cables to manage, lower

cost per connection, centralized wiring for greater control. These units feature exceptional noise immunity and a new technology that allows simultaneous

operation over existing UTP wiring within a building. Perfect for larger CCTV installations where need install many cameras, difficult in using coaxial cable,

existing many interference environment. .Such as: School, airport, park, department, casino, elevator, hospital, parking lot, electricity plant, prison, shopping

mall, traffic control...etc.

TTP111V Video Transceiver BNC Male To RJ-45 female
Features:

BNC male to RJ45 female.
Transmit a full motion color or monochrome video signal up to 600 meters.
Distance up to 1Km when used with an active receiver such as TTA-111V.
Includes CAT 5 RJ45 male to 2 screw terminal adapter.
Passive, no power required.
Built in impedance couple device and noise filter for exceptional interference immunity.
Up to 16 pieces TTP-111V can work with 1U rack mounting TPP016 receiver panel.

TTP111VT Video Transceiver BNC Male To Terminal Block
Features:

BNC male to terminal Block.
The other features are identical to above.

TTP111VF Video Transceiver F Male To Terminal Block
Features:

F male to terminal Block.
The other features are identical to above.

TTP111VP Video Transceiver BNC Male To RJ45 Female With Power Cord

Features:

BNC male + DC plug to RJ45 female.
Use with TTP111VPJ, transmit video & power over one Cat 5 cable. (range 50meters).
Use with TDP414VP for power transmission 4 cameras from remote site

DIY KIT: TTP111VPK ( TTP111VP + TTP111VPJ)

RJ45 pin connect

Pair 1 : 1. Orange-white & 2. Orange

Pair 2 : 3. Green-white & 6. Green

Pair 3 : 4. Blue & 5. Blue-white → Power

Pair 4 : 7. Brown-white & 8. Brown → Video

TTP111VCT Video Transceiver With 18cm Retractile Cord

Features:

BNC male to screw terminals with 18cm Retractile Cord.
Weather Proof. IP65
Perfect for camera with pan-tilt turning device.

TTP111VL Video Transceiver with 25cm mini coax cable
Features:

BNC male to terminal Block.
Weather Proof. IP65
TTP111VL compact size, perfect to connect with the image processor, which have multi BNC connections, as like Multiplexer, Quad, DVR …etc.

DIY KIT: TTP111VK ( TTP111VT + TTP111VL)

Network cable pin connect

1. Orange-white

2. Orange

3. Green-white

4. Blue

5. Blue-white

6. Green

7. Brown-white

8. Brown

TTP111VPD Video, Data, Power Transceiver

Features: 　

Male BNC with DC Plug+2 pin pigtail to 6 “push pin” terminal.
Video , camera power, Data ( RS422, 485) transmission over one standard CAT 5 cable.
Push pin terminal for easy cable connection.

TVB001 Twisted Pair VIDEO BALUN

Features: 　

Eliminate interference under long range cabling caused by "Impedance Matching", add TVB001 BALUN at "connecting point" between two-wire connections for compensation.
Including 4 pieces UY connectors for connection.

TTP111VH Video Transceiver With Extra Interference Rejection
Features:

BNC female to terminal block.
Perfect work with DVR to immunity DVR interference.
Built in a highly balanced mode of video transmission, which is immune to interference from these, and other sources of noise: Data signals, other video signals, nearby power, ringing telephones, fluorescent lights, transformers, and more...

TTP111AV Video & Audio Transceiver

Features:

BNC male + 2 RCA female to RJ45 female.
Video and stereo audio transmission.

Specification

ITEM	TTP111VF	TTP111VT	TTP111VH	TTP111V	TTP111VCT	TTP111VP	TTP111AV
Video Input (BNC Connector)	F	1	1	1	1	1	1
Video Input	1Vp-p, 75ohms	1Vp-p, 75ohms	1Vp-p, 75ohms	1Vp-p, 75ohms	1Vp-p, 75ohms	1Vp-p, 75ohms	1Vp-p, 75ohms
Audio Input (RCA Connector)	X	X	X	X	X	X	2Way
Audio Input	X	X	X	X	X	X	2V p-p
RJ-45 Input	X	X	X	X	X	X	X
RJ-45 Output	Terminal	Terminal	Terminal	1	1	1	1
Transmission Distance	600 M (B/W), 400M(COLOR)
Cable for RJ-45	Twisted Pair CAT 5 ( AWG 24 )
Power	X	X	X	X	X	X	X
Dimension W x H x D mm	69x25x22	69x25x22	88x38x27	69x25x22		69x25x22	110x77x24

TTP414V 4 Channel Video Transceiver 4 x BNC Female to 1 x RJ45 Female
Features:

4 x BNC female to 1x RJ45 female + 8 pin Terminal block
Four passive transceivers in one product.

TTP414VH 4 channel video transceiver with Extra Interference Rejection
Features:

4 BNC female to 1 x RJ45 female.
Perfect work with DVR to immunity DVR interference.
Built in a highly balanced mode of video transmission, which is immune to interference from these, and other sources of noise: Data signals, other video signals, nearby power, ringing telephones, fluorescent lights, transformers, and more...

TTP414VD 4 Channel Video Transceiver With Data

Features:

4 x BNC female + 1 x RJ45 female + 1x terminal block ( for data transmission : pan, tilt, zoom ).
Using 4 pairs CAT 5 cable to transmit/receive 3 sets video signals plus 1 data signal or transmit/receive 4 sets video signals only.

TTP444V Front

TTP444V 4 Channel Video Transceiver 4 x BNC Female to 4 x RJ45 Female
Features:

4 x BNC female to 4 x RJ45 female.
Four passive transceivers in one product.

TTP444VPD 4 Channel Video, Power, Data Transceiver
Features:

4 x BNC female + DC power to 4 x RJ45 female + 2 pin terminal for DATA.
Video, camera power, Data (RS422, 485) transmission over one standard CAT 5 cable.
Built in PTC fuse for short protection.
Application for color video signal up to 300 meters, B/W to 600 meters.
Use with TTP111VPD/VP, transmit 4 channels video, power, data over 4 CAT 5 cable.

Specification

ITEM	TTP414V	TTP414VH	TTP414VD	TTP444V
Video Input (BNC Connector)	4	4	4	4
Video Input	1V p-p, 75 Ohms	1V p-p, 75 Ohms	1V p-p, 75 Ohms	1V p-p, 75 Ohms
Audio Input (RCA Connector)	X	X	X	X
Audio Input	X	X	X	X
RJ-45 Input	X	X	X	X
RJ-45 Output	1	1	1	4
Transmission Distance	600M(B/W), 400M(COLOR)
Cable for RJ-45	Twisted Pair CAT5 (AWG24)
Power	X	X	X	X
Dimension W x H x D mm	110x77x24	138x66x28	138x66x28	110x77x24

Twisted Pair Transmission Transceiver - ACTIVE Series

Active Video Transceiver (power required), transmission range color 1500 meters, B/W 2400 meters via CAT 5 UTP Cable.

TTA111AV Video & Audio & Data Twisted Pair Transmission

TTA111AVT Transmitter, TTA111AVR Receiver
Features:

Transmit video, audio and data signal (RS422, RS485).
Three position range switch for gain select on transmitter.
Five position distance range switch on Receiver, brightness adjustment, two video output.
Built in transient protection and ground lifting.

TTA111AVT -

Transmitter (back)

TTA111AVT -

Transmitter (Front)

TTA111V Video Twisted Pair Transceivers

TTA111VT Transmitter, TTA111VR Receiver

Features:

Three position range switch for gain select on transmitter.
Five position distance range switch on Receiver, brightness adjustment.
Built in transient protection and ground lifting.
System is integrated with alarm sensor (PIR, Magnetic, etc...) or data (Pan, Tilt, Zoom ).

TTA111AVR -Receiver (back)

TTA111AVR -Receiver (front)

TTA111VT-Transmitter

TTA111VR-Receiver

Specification

ITEM	TTA111AVT	TTA111VT
Video input	1 Vp-p, 75 Ohms (BNC connector)
DC input	DC12V
DC output for CCD camera	DC 12V Regulate, 300mA(max)
Power consumption	40mA(max)
Dimensions W x H x D mm	109x77x24	49x42x45

Specification

ITEM	TTA111AVR	TTA111VR
Video input	1 Vp-p, 75 Ohms (BNC connector)
DC input	DC12V
Power consumption	40mA(max)
Video gain adjusting	Press1 0~300M
	Press2 300~600M
	Press3 600~900M
	Press4 900~1200M
	Press5 1200~1500M
Recommended cable	CAT-5 UTP Cable 4 pair (AWG24)
Dimensions W x H x D mm	109x77x24	49x42x45

Note: Recommend STP (Shielding Twisted Pair) cable and use surge protector SP003/SP004 to avoid the damage of twisted pair system under lightning, thunderstorm weather environment.

Application:

TTA111AV, TTA111V both are active (amplified) devices that allow transmission of real-time color or monochrome audio & video signal, data up to 2400 meters over industry CAT 5 twisted pair networking cable. Perfect for CCTV in need of long cable runs between buildings and utilizing existing wiring in large facilities. A pair of wires is also dedicated for security alarm or pan/tilt/zoom data applications. Selectable switch setting for cable length. A remote DC power supply can provides power for 12VDC (24VAC-TTA111V) color or monochrome cameras via WT-104P cable.

TTA111VH Active Receiver With Extra Interference Rejection
Features:

Built in a highly balanced mode of video transmission for extra interference immunity.
HF, MF, LF compensation for color gain and adjustable brightness & contract for cleaner, sharper looking picture.
Built in Input Impedance, Balance, Liner Gain adjustment.
Built in Surge Protection.
Perfect to maintain good quality picture for long-range transmission with DVR.
Using two sets TTA111VT+TTA111VH for series connection, range up to 2.4Km(Color), 3Km(B/W).

Specification
ITEM	TTA111VH
Video input	0.12-2 Vpp
Input impedance	45-175 Ohms
Video output	1 Vpp, 75 Ohms
Freq. response	50 Hz - 5MHz (-3 dB)
Disturbance reduction	> 70dB, 50Hz
Gain adjustment	+ 6 dB...+ 60 dB at 5MHz
Noise	-50 dB at+40 dB gain adj. -47 dB at+60 dB gain adj.
Power consumption	DC 12V, 150mA (max)
Input protection	Surge arrester
Indicators	LED (Red)-power on
Distance (M)	SW1 (1-8), SW2 (1-8)
0-300	X
300-600	SW1 (1, 2) to SW1 (1, 2, 3) up
600-900	SW1 (1, 2,3 ) to SW1 (1, 2, 3, 4, 5) up
900-1200	SW1 (1, 2, 3, 4, 5, 6) to SW1 (1, 2, 3, 4, 5, 6, 7, 8) + SW2 (1) up
1200-1500	SW1 (1, 2, 3, 4, 5, 6, 7, 8) + SW2 (1) to SW1 (1, 2, 3, 4, 5, 6, 7, 8) + SW2 (1, 2, 3, 4, 5) up
Material	ABS
Dimension W x H x D mm	138x77x28

TTA414VR 4 Channel Active Receiver

Features:

Built in 4 port active receivers.
Others identical same as TTA111VR.

Specification

ITEM	TTA414VR
Video input	1 Vp-p, 75 Ohms (BNC connector)
DC input	DC 12V
DC output for CCD camera	DC 12V Regulate, 300mA(max)
Power consumption	150mA (max)
Dimension W x H x D mm	138x66x28

OPTION:
To protect high value camera and CCTV image processor/monitoring equipment destroyed from high voltage surges from nearby lightning strikes, the long-range twisted pair cable go through outdoors. To add surge protection SP003-SP006 device on the back of camera and front of CCTV image processor / monitoring equipments. Small money to save high value CCTV equipments.

65-67852171 email: sales@securitex.com.sg

To purchase the above system or arrange for a site demo please contact us at the above number or email our technical personnel will contact you and discuss with you in more detail.

Back to Securitex Electronic Systems Engineering